Step by Step
Programming sensor keys
78
Configuring repdial/direct station
selection keys
Direct station selection keys can be assigned an internal
number from the HiPath 4000 network.
A typical application of direct station selection keys is
the executive-secretary configuration Æ page 112.
You can program repdial keys with external phone num-
bers on two levels. To program the second level, you
must configure a "Shift" key Æ page 77.
See also Æ page 17.
Prerequisite: You have programmed a sensor key with
the function "Repdial" or "Direct station select"
Æ page 77.
N Open the Program/Service menu Æ page 26.
Confirm the option shown.
Select and confirm the option shown.
or
Select and confirm the option shown.
Press the configured repdial key,
or
Press the configured direct station select key.
Defining the phone number
j Enter the number
Confirm the option shown.
Confirm the option shown. Your entry is saved.
Your telephone can be configured so that direct
station selection keys cannot be set up, thus fa-
cilitating data and personal security. Contact your
service personnel should you have questions.
Destinations? g
Repdial?
Direct Station Select?
R
DSS
Enter new number?
Completed?
To Next Page
Loading...
Need help?
General
