Prerequisites 1 - 3
Siemens AG RXB8-115.061.02 Page 3 of 4 POLYMOBIL III
Medical Solutions Rev. 01 10.95 CS PS 24
Replacing damaged or missing screws 1
• Damaged or missing screws must only be replaced by steel screws as specified in the
installation drawings that conform to DIN 267 and have the specified tensile strength.
Cleaning 1
• The unit must always be switched off or disconnected before cleaning.
• Use only water or a luke warm mixture of a household cleaner diluted with water to clean
the unit.
• Do not use an abrasive or organic solvents or cleaning agents containing solvents such
as gasoline used for cleaning purposes, alcohol or stain remover. Do not spray water on
the unit.
• For further information, refer to the Operating Instructions "Cleaning/Disinfecting".
All Allen screws must have a tensile strength rating of 8.8.
CAUTION
To Next Page
Loading...
