Certifications and approvals
8.1 EU declaration of conformity
SCALANCE X-100
62 Operating Instructions, 12/2016, A2B00060666-08
Personal injury and property damage can occur
The installation of expansions that are not approved for SIMATIC NET products or their
target systems may violate the requirements and regulations for safety and electromagnetic
compatibility.
Only use expansions that are approved for the system.
Note
The test was performed with a device and a connected communications partner that also
meets the requirements of the standards listed above.
When operating the device with a communications partner that does not comply with these
standards, adherence to the
corresponding values cannot be guaranteed.
EU declaration of conformity
The EC Declaration of Conformity is available for all responsible authorities at:
Siemens Aktiengesellschaft
Process Industries and Drives Division
Process Automation
DE-76181 Karlsruhe
Germany
You will find the EC declaration of conformity for these products on the Internet pages of
Siemens Industry Online Support
(https://support.industry.siemens.com/cs/ww/en/ps/15273/cert
).
The SIMATIC NET products described in these Operating Instructions meet the
requirements of the following EC directives:
● 94/9/EC
ATEX directive of the European Parliament and the Council of 23 March 1994 on the
approximation of the laws of the Member States concerning equipment and protective
systems intended for use in potentially explosive atmospheres (until 19.04.2016).
● 2014/34/EU
ATEX directive of the European Parliament and the Council of 26 February 2014 on the
approximation of the laws of the member states concerning equipment and protective
systems intended for use in potentially explosive atmospheres (as of 20.04.2016).
To Next Page
Loading...
