Testing
58
This message will appear if you enter a setting value that does
not exist. For example, if the trip unit has continuous current
settings of 50, 60, 65, 70, 75, 80, 85, 90, 95, and 100 percent,
and you enter any other value than those listed, the above
message will appear.
Test exceeds capability of TS-31
Press ENTER to continue
If this message occurs, it means that a test requires more cur-
rent to run than the TS-31 can produce.
Unit too hot! please wait
Running many successive, high-current, long time tests may
over-heat the test set. It will protect itself from thermal damage
by asking the user to wait and allowing the TS-31 to cool down.
To Next Page
Loading...
Need help?
General
