Siemens SIMATIC ET 200AL - Page 1008

Parameter assignment/addressing
3.2 Device name and IP address
PROFINET with STEP 7 V15
Function Manual, 12/2017, A5E03444486-AH
61
4. In the "PROFINET" area, select the " PROFINET device name is set directly at the
device" check box.
Figure 3-9 Setting the device name and IP address on the device
Note
Gateway
When you operate a PROFINET device with the option "Allow adaption of the device
name/IP address directly on device", you cannot use this PROFINET device as gateway
for S7 routing.
Options for assigning IP addresses and device names
Apart from the known address and device name assignment in the "Ethernet addresses"
section of the Inspector window, there are other ways in which the IP address and name can
be assigned:
● Assigning by means of the user program with the instruction "T_CONFIG"
● Assignment when downloading the configuration to the target system via the "Extended
download to device" dialog box.
● Assignment via the Primary Setup Tool (PST)
● Assignment via the PRONETA ("PROFINET network analysis") commissioning and
diagnostics tool
● Assignment via the SIMATIC Automation Tool
Additional information
For information on the "T_CONFIG" instruction and on downloading to the target system,
refer to the STEP 7 online help.
A free Download (http://support.automation.siemens.com/WW/view/en/14929629
) of the
Primary Setup Tool (PST) can be found on the Internet. On this Internet page, you will also
find a list of devices for which the PST is approved.