Siemens SIMATIC ET 200AL - Configuration Software Requirements

Time-based IO basics
2.5 Configuration software requirements
High-precision input/output with Time-based IO
Function Manual, 08/2014, A5E33454822-AB
19
2.5
Configuration software requirements
Introduction
Below please find a list of the software versions which support the "Time-based IO" function.
Requirements
Configuration software
Requirements
Supported hardware components
Additional information
STEP 7 (TIA Portal) as of
V13
• PROFINET IO IRT
• For CM 4xIO-Link:
IO-Link technology
• S7-1500 automation system
• ET 200SP and ET 200MP
distributed I/O systems
• CM 4xIO-Link
• TM Timer DIDQ 16x24V (as of
V13 Update 3)
• TM Timer DIDQ 10x24V (as of
V13 Update 3)
TIA Portal online help
S7-PCT as of V3.2 —
• CM 4xIO-Link
S7-PCT online help
TIO instructions
The TIO instructions are specific function blocks for use of Time-based IO. The following TIO
instructions (Page 29) are available:
● TIO_SYNC
● TIO_IOLink_IN
● TIO_IOLink_OUT
● TIO_DI
● TIO_DQ
As of V13 Update 3, the TIO instructions are available as integrated instructions in
TIA Portal.