Parameter assignment/addressing
3.5 Configuring topology
PROFINET with STEP 7 V15
72 Function Manual, 12/2017, A5E03444486-AH
To interconnect ports in the topology view, follow these steps:
1. Place the pointer of the mouse on the port you want to interconnect.
2. Press and hold down the left mouse button.
3. Move the pointer.
The pointer now uses the networking symbol to indicate "Interconnecting" mode. At the
same time, you see the lock symbol on the pointer. The lock symbol disappears only
when the pointer is over a valid target position.
4. Now drag the pointer to the target port. You can keep the left mouse button pressed or
release it when performing this action.
5. Now release the left mouse button or press it again (depending on your previous action).
Figure 3-15 Interconnecting ports in the topology view
You have created a port interconnection.
To Next Page
Loading...
