Functions
5.5 Real-time communication
PROFINET with STEP 7 V15
182 Function Manual, 12/2017, A5E03444486-AH
Setting the bandwidth usage
To set the bandwidth usage for a PROFINET IO system in STEP 7, follow these steps:
1. Select your IO system in the network view of STEP 7.
2. In the Inspector window, go to "Properties" > "General" > "PROFINET" > "Domain
management" > "Sync domains" > "Name of the sync domain" > "Details".
3. Select the desired level of bandwidth usage from the "Bandwidth use" drop-drop down list
box.
Figure 5-49 Setting the bandwidth usage
For information on how to set the bandwidth usage for IRT with maximum performance, refer
to the section Configuration of IRT with high performance (Page 193)
To Next Page
Loading...
