Siemens SIMATIC ET 200AL - Page 125

Application planning
Product Information Mixed Configuration ET 200SP / ET 200AL
6 Product Information, 02/2016, A5E33344611-AC
Requirement
The following components support mixed configuration:
● Interface module
– IM 155-6 PN HF (V3.0 or higher)
– IM 155-6 PN ST (V3.1 or higher)
– IM 155-6 DP HF (V3.0 or higher)
● CPU
– CPU 1510SP-1 PN (V2.0 or higher)
– CPU 1510SP F-1 PN (V2.0 or higher)
– CPU 1512SP-1 PN (V2.0 or higher)
– CPU 1512SP F-1 PN (V2.0 or higher)
● BaseUnit BU-Send with BusAdapter BA-Send 1xFC
● ET-Connection cable
● Power cable
Rules
You must observe the following rules when assembling a mixed configuration:
● The bus length of the ET 200SP distributed I/O system must not exceed 1 m
(without interface module, including BU-Send/BA-Send 1xFC and server module)
● A maximum of 16 ET 200AL I/O modules can be connected to ET-Connection.
● The maximum length of the bus cable for ET-Connection between BA-Send and the first
module or between two modules is 15 m.
The following table shows which firmware versions of your IM or CPU support which
maximum bus cable length.
IM/CPU
2 m
5 m
10 m
15 m
IM 155-6 PN HF
V3.0 or higher
V3.0 or higher
V3.0 or higher
V3.3 or higher
IM 155-6 PN ST V3.1 or higher V3.1 or higher V3.1 or higher V3.3 or higher
IM 155-6 DP HF
V3.0 or higher
V3.0 or higher
V3.0 or higher
--
CPU 1510SP-1
PN
V2.0 or higher V2.0 or higher V2.0 or higher V2.0 or higher
CPU 1510SP F-1
PN
V2.0 or higher V2.0 or higher V2.0 or higher V2.0 or higher
CPU 1512SP-1
PN
V2.0 or higher V2.0 or higher V2.0 or higher V2.0 or higher
CPU 1512SP F-1
PN
V2.0 or higher V2.0 or higher V2.0 or higher V2.0 or higher