Siemens SIMATIC ET 200AL - Page 1361

Preface
Analog value processing
4 Function Manual, 06/2014, A5E03461439-AC
Conventions
STEP 7: In this documentation, "STEP 7" is used as a synonym for "STEP 7 as of V12
(TIA Portal)" and subsequent versions of the configuration and programming software.
This documentation includes images of the products it describes. The products supplied may
differ slightly from these images.
Please observe notes labeled as follows:
Note
Notes contain important information on a point in the documentation of particular importance.
Additional support
Additional information on SIMATIC products is available on the Internet. The associated
documentation is also available on the Internet.
● The portfolio of technical documentation for SIMATIC products and systems can be
accessed on the Internet (http://www.siemens.com/simatic-tech-doku-portal).
● The online catalog and the ordering system are available on the Internet
(http://mall.automation.siemens.com).
Security information
Siemens provides products and solutions with industrial security functions that support the
secure operation of plants, solutions, machines, equipment and/or networks. They are
important components in a holistic industrial security concept. With this in mind, Siemens’
products and solutions undergo continuous development. Siemens recommends strongly
that you regularly check for product updates.
For the secure operation of Siemens products and solutions, it is necessary to take suitable
preventive action (e.g. cell protection concept) and integrate each component into a holistic,
state-of-the-art industrial security concept. Third-party products that may be in use should
also be considered. You can find more information about industrial security on the Internet
(http://www.siemens.com/industrialsecurity).
To stay informed about product updates as they occur, sign up for a product-specific
newsletter. You can find more information on the Internet
(http://support.automation.siemens.com).