Communication module CM 4xIO-Link 4xM12(6ES7147-5JD00-0BA0)
Manual, 10/2017, A5E32352322-AE
33
Pause function
Introduction
PROFIenergy is a PROFINET-based data interface for switching off consumers centrally and
in a coordinated manner during pause times regardless of the manufacturer or device type.
This has the aim that the process is only provided with the energy that is absolutely required.
In so doing, the majority of the energy savings come from the process itself; the PROFINET
device contributes only a few watts to the possible savings. In PROFIenergy, this operating
state is referred to as a "pause".
You enable and disable the pause function of the system at the beginning and end of
pauses, respectively; the IO controller then sends the PROFIenergy command "Start_Pause"
or "End_Pause" to the modules.
Use the "Start_Pause" command to start a pause.
Use the "End_Pause" command to end a pause.
The following conditions will also cause a pause to be ended:
● Reconfiguration in RUN
● Controller failure
● Firmware update
● Station stop
● Restart of the interface module through:
– POWER OFF/POWER ON of an interface module
– POWER OFF/POWER ON of an I/O module
– Termination of ET-Connection1 or ET-Connection2
The specific behavior of the communication module is explained in the following sections.
You can find additional information on working with PROFIenergy in the "PROFIenergy"
section of the manual IM 157-1 PN interface module
(http://support.automation.siemens.com/WW/view/en/89254863) and the "Saving energy
with PROFIenergy" section of function manual PROFINET with STEP 7 V13
(http://support.automation.siemens.com/WW/view/en/49948856).
Application examples (http://support.automation.siemens.com/WW/view/en/41986454) are
also available on the Internet.
To Next Page
Loading...
