Siemens SIMATIC ET 200AL - Page 645

Setting and determining system diagnostics
4.2 Options for displaying system diagnostics
Diagnostics
60 Function Manual, 09/2016, A5E03735838-AD
Procedure
Proceed as follows to configure the system diagnostics:
1. Double-click the "System diagnostics view" object in the "Tools" task card. The object is
added to the screen.
Figure 4-27 Adding a system diagnostics view
2. Select the "Properties" tab in the Inspector window.
3. Select the area "Columns".
4. Enable the columns that you require in the device view for WinCC Runtime, for example:
– Status
– Name
– Operating mode
– Slot
– Address
5. Enable the columns that you require in the detail view for WinCC Runtime, for example:
– Status
– Name
– Operating mode
– Plant designation
– Address
6. You can change the column headers in the "Columns" area, if necessary.
7. Select the "Display" area.
8. Enable "Column settings > Columns moveable" to move the columns in WinCC Runtime.
9. To close the system diagnostics window in WinCC Runtime, select "Properties > Window
> Closable" in the "Properties" tab of the Inspector window.