Siemens SIMATIC ET 200AL - Technical Specifications; General Specifications and Product Function

Commissioning
8.3 Identification and maintenance data
Distributed I/O system
System Manual, 02/2018, A5E31861578-AF
75
Procedure for input of maintenance data using STEP 7
The default module name is assigned by STEP 7. You have the option to enter the following
data:
● Plant designation (I&M1)
● Location identifier (I&M1)
● Installation date (I&M2)
● Additional information (I&M3)
● Signature (I&M4), only for PROFINET
To enter the data, follow these steps:
1. In the device view of the STEP 7 hardware network editor, select the interface module, for
example.
2. In the properties under "General", select the "Identification & Maintenance" area and
enter the data.
During the loading of the hardware configuration, the I&M data are also loaded.
Reference
You can find additional information on I&M data of the ET 200SP (mixed configuration) in the
ET 200SP distributed I/O system
(https://support.industry.siemens.com/cs/ww/en/view/58649293
) system manual.