Open User Communication
6.9 Setting up communication via FTP
Communication
90 Function Manual, 12/2017, A5E03735815-AF
Procedure for setting up FTP server functionality
Requirement:
The FTP server can be reached via the IPv4 network
1. Configure an S7-1500 automation system with CPU and CP 1543-1 in the device view of
the Devices & networks editor of STEP 7.
At the same time, you need to select the check box "Permit access with PUT/GET
communication from remote partner (PLC, HMI, OPC, ...)" in the HW configuration of the
S7-1500 CPU under the "Protection" area navigation in the section "Connection
mechanisms".
2. Make the following settings in the properties of the CP under "FTP configuration":
– Select the "Use FTP server for S7 CPU data" check box.
– Assign the CPU, a data block and a file name under which the DB for FTP will be
stored.
Figure 6-11 Setting up the FTP configuration
3. Download the hardware configuration to the CPU.
To Next Page
Loading...
