EasyManua.ls Logo

Siemens SIMATIC ET 200AL - Page 973

Siemens SIMATIC ET 200AL
1585 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Description
2.1 Introduction to PROFINET
PROFINET with STEP 7 V15
26 Function Manual, 12/2017, A5E03444486-AH
Examples of identification
Three examples illustrate the rules for identifying PROFINET interfaces:
Table 2- 4 Examples for identifying PROFINET interfaces
Sample labeling
Interface number
Port number
X2 P1
2
1
X1 P2 1 2
X1 P1 R
1
1 (ring port)
Representation of PROFINET Interfaces in the Topology Overview in STEP 7
You can find the PROFINET interface in the topology overview in STEP 7. The PROFINET
interface for an IO controller and an IO device is represented as follows in STEP 7:
Number
Description
PROFINET interface of an IO controller in STEP 7
PROFINET interface of an IO device in STEP 7
These lines represent the PROFINET interface.
These lines represent the "ports" of a PROFINET interface.
Figure 2-5 Representation of the PROFINET interfaces in STEP 7
Schematic Representation of a PROFINET Interface with Integrated Switch
The following schematic diagram shows the PROFINET interface with integrated switch and
its ports for all PROFINETdevices.
Figure 2-6 PROFINET interface with integrated switch

Table of Contents

Other manuals for Siemens SIMATIC ET 200AL

Related product manuals