Siemens SIMATIC ET 200SP F-AI 4xI 0(4) 20mA 2-/4-wire HF Series - Page 57

Interrupts/diagnostic messages
6.2 Interrupts
Analog input module F-AI 4xI 0(4)..20mA 2-/4-wire HF (6ES7136-6AA00-0CA1)
Manual, 08/2018, A5E41448857-AB
57
● Diagnostics memory overflow
● Channel failure acknowledgment
● F-address memory not accessible
● No valid F-address available
● Diagnostics memory overflow
● Undertemperature
● Supply voltage too high
● Supply voltage too low
● Channel/component not available
Scope of diagnostic interrupt: Channel
● Diagnostics: Wire break (can only be configured for measuring range 4..20mA)
● High limit exceeded
● Low limit violated
● Safety-related switch off
● Internal supply voltage of the module failed
● Common mode error
● Analog input signal not recorded unique
● Internal sensor supply short-circuit to P
● Overload or internal sensor supply short-circuit to M
● Discrepancy error
● Analog input signal not recorded unique
● Internal sensor supply short-circuit to P
● Overload or internal sensor supply short-circuit to M
● Read back failure
● ADC error
● Fault in test circuit