Siemens SIMATIC HMI KTP900 Basic User Manual

Commissioning a project
6.3 Data transmission options
Basic Panels 2nd Generation
Operating Instructions, 10/2016, A5E33293231-AB
75
6.3
Data transmission options
Overview
The following table shows the options for data transfer between the HMI device and the
configuration PC.
Action
Data channel
Basic Panels DP
Basic Panels
with PROFINET
interface
Backup/restore,
Update operating system,
Transfer project
MPI/PROFIBUS DP
Yes
-
PROFINET - Yes
USB
Yes
Yes
Update operating system with
"Reset to factory settings"
MPI/PROFIBUS DP
-
-
PROFINET
-
Yes
USB
Yes
Yes
Assign IP address and device
name, edit communication
connections
PROFINET - Yes
6.4
Transfer
6.4.1
Overview
Transfer the executable project from the configuration PC to the HMI device.
You can start the "Transfer" mode manually or automatically on the HMI device.
Transferred data is written directly to internal flash memory of the HMI device. Assign
parameters of a corresponding data channel before you start the transfer.
6.4.2
Starting the manual transfer
Introduction
You can manually switch the HMI device to "Transfer" mode as follows:
● At runtime, using a configured operating element.
● In the Start Center of the HMI device.

Siemens SIMATIC HMI KTP900 Basic Specifications

General

Display Size	9 inches
Display Type	TFT
Resolution	800 x 480 pixels
Touchscreen	Yes
Interface	PROFINET
Power Supply	24 V DC
Operating System	Windows CE
USB Port	1 x USB 2.0
Ambient Temperature (Operation)	0 to 50 °C
Ambient Temperature (Storage)	-20 to 60 °C
Relative Humidity	10% to 90% (non-condensing)
Protection Rating	IP65 (front)
Memory	12 MB
Communication Ports	Ethernet (RJ45)
Number of Colors	65536