Siemens SIMATIC HMI KTP900 Basic User Manual

Commissioning a project
6.9 Managing WinCC options
Basic Panels 2nd Generation
92 Operating Instructions, 10/2016, A5E33293231-AB
5. Switch on the HMI device.
The HMI device detects the USB memory stick containing the Recovery Software. The
"Recovery Mode" dialog is displayed.
6. To reset the HMI device to factory settings, press the "START RECOVERY (..3..)" button
three times in a row and follow the instructions on the display. At the end of the recovery
operation, remove the USB memory stick and press the "REBOOT" button.
6.9
Managing WinCC options
You can install the following WinCC options on an HMI device:
● WinCC options supplied with WinCC for the Engineering System and Runtime
● WinCC options purchased in addition to WinCC for the Engineering System and Runtime
The HMI device type determines which WinCC options can be installed.
For an overview of available WinCC options, refer to "Introduction to WinCC".
Requirement
● The HMI device is connected to the configuration PC.
● The PG/PC interface is set.
● The HMI device is selected in the project tree.
● The HMI device is switched on.

Siemens SIMATIC HMI KTP900 Basic Specifications

General

Display Size	9 inches
Display Type	TFT
Resolution	800 x 480 pixels
Touchscreen	Yes
Interface	PROFINET
Power Supply	24 V DC
Operating System	Windows CE
USB Port	1 x USB 2.0
Ambient Temperature (Operation)	0 to 50 °C
Ambient Temperature (Storage)	-20 to 60 °C
Relative Humidity	10% to 90% (non-condensing)
Protection Rating	IP65 (front)
Memory	12 MB
Communication Ports	Ethernet (RJ45)
Number of Colors	65536