Expanding and assigning parameters to the device
6.2 Installing the M.2 Module
SIMATIC IPC277G
Operating Instructions, 08/2021, A5E50059956-AA
53
Procedure - Installing the flexible module
Unscrew the marked screw.
Align the golden finger on the M.2 Module on your
motherboard, and then press firmly until the M.2
Module is completely seated on the slot.
Secure the M.2 Module with the screw which is
unscrewed in the first step.
Note: Make sure the M.2 Module board is located
between head and spacer of assembly screw.
If the M.2 Module has a cable with an additional interface-card connect to the housing opening, you
need to do the following procedures:
To Next Page
Loading...
