Siemens SIMATIC IPC677D - 8.6.4 Exit menu; 8.6.5 General BIOS Setup settings

Technical information
8.6 BIOS description
SIMATIC IPC677D
Operating Instructions, 09/2014, A5E32995420-AC
157
8.6.4
Exit menu
You always exit BIOS Setup in this menu.
Exit Saving Changes All changes are saved and the system is restarted with the new Setup
parameters.
Save Change Without
Exit
All changes are saved
Exit Discarding Changes All changes are discarded and the system is restarted with the old Setup
parameters.
Load Optimal Defaults All setup parameters are reset to the safe default values.
Notice: The existing Setup parameters are overwritten by this.
Load Custom Defaults The profile must be loaded with the custom Setup parameters.
Requirement: The parameters are saved prior to this with "Save Custom
Defaults".
Save Custom Defaults The currently configured Setup parameters are saved as a custom profile
(see also "Load Custom Defaults").
Discard Changes
All changes are discarded.
8.6.5
General BIOS Setup settings
If you have changed any default settings in Setup, you can enter them in the following table.
You can then refer to these entries for any future hardware modifications.
Note
Print out the table below
and keep the pages in a safe place once you made your entries.
The default setup settings vary depending on the ordered device configuration.