Siemens SIMATIC S7-300 Module data Product Information

SINAMICS S120 automation components
2.7 SINAMICS Support Packages
Connection of the SINAMICS S120 to the Technology CPU
14 Product Information, 09/2011, A5E00480378-04
Installation
All SSPs released for a product version can be installed in any order.
Do not run STARTER/S7 Technology during SSP installation.
To install a new SSP from CD, follow these steps:
1. Place the SSP CD into the CD drive of your programming device/PC,
or save and unpack the SSP you downloaded from Product Support.
2. Select and run setup.exe in Windows Explorer
3. Follow the installation instructions and restart the computer after successful installation.
After having successfully completed installation, you can open S7T Config to configure the
SINAMICS versions you installed in offline mode, or to operate them in online mode
(for example, by selecting "Accessible nodes").
The SINAMICS Support Packages you installed are displayed as "SSP SINAMICS ..."
in SIMATIC > Product Information > Installed Software , "Components" tab.

Siemens SIMATIC S7-300 Module data Specifications

General

Series	S7-300
Manufacturer	Siemens
Protection Class	IP20
System	SIMATIC S7-300
Digital Inputs	Varies by module
Digital Outputs	Varies by module
Analog Inputs	Varies by module
Analog Outputs	Varies by module
Central Processing Unit	Varies by CPU model
Supply Voltage	24V DC or 120/230V AC
CPU Type	Varies (e.g., CPU 312, CPU 315, etc.)
Memory	Varies by CPU model
Communication Interfaces	MPI, PROFIBUS
Programming Languages	LAD, FBD, STL, SCL, GRAPH
Operating Temperature	0°C to 60°C
Storage Temperature	-40°C to 70°C
Relative Humidity	10% to 95% (non-condensing)