Siemens SIMATIC S7-300 Module data Product Information

Connection of the SINAMICS S120 to the Technology CPU
Product Information, 09/2011, A5E00480378-04
3
Table of contents
1 Definitions and warnings............................................................................................................................ 7
2 SINAMICS S120 automation compo
nents................................................................................................. 9
2.1 Sy
stem overview............................................................................................................................9
2.2 Control unit
.....................................................................................................................................9
2.3 Line Modules
................................................................................................................................10
2.4 Motor Modules
.............................................................................................................................10
2.5 Expansion and system
components ............................................................................................11
2.6 Determining the firmware
version number...................................................................................11
2.7 SINAMICS Support Packages
.....................................................................................................13
3 Commis
sioning ........................................................................................................................................ 15
3.1 Commiss
ioning procedure ...........................................................................................................15
3.2 Connecting hardware com
ponents ..............................................................................................15
3.2.1 PROFIBUS interconnec
tion .........................................................................................................15
3.2.2 Interconnecti
on of the DRIVE-CLiQ components ........................................................................17
3.2.3 Additional ha
rdware wiring for Smart Line Modules without DRIVE-CLiQ ..................................21
3.2.4 Special features of the SINAMICS S120 Traini
ng Case..............................................................22
3.3 Preparing the c
onnection to the SINAMICS ................................................................................23
3.3.1 Ov
erview ......................................................................................................................................23
3.3.2 Creating a S
TEP 7 project ...........................................................................................................23
3.3.3 Configuring in HW Config
............................................................................................................24
3.3.4 Ac
tivating routing in NetPro .........................................................................................................30
3.4 Configuring the dri
ve components ...............................................................................................35
3.4.1 Ov
erview ......................................................................................................................................35
3.4.2 Automatic
configuring ..................................................................................................................35
3.4.3 Manual
configuring.......................................................................................................................39
3.4.4 Alignment of the PROFIdrive mess
age frames ...........................................................................69
3.4.5 Loadi
ng the configuration into the drive components ..................................................................70
3.4.6 Optimiz
ing the speed controller in the drive.................................................................................71
3.5 Diagnos
ing the SINAMICS configuration.....................................................................................75
3.5.1 Check
ing the DRIVE-CLiQ wiring online .....................................................................................75
3.5.2 Dri
ve test using the SINAMICS control panel..............................................................................76
3.6 Creating technology
objects.........................................................................................................78
3.6.1 Creating and c
onfiguring axes .....................................................................................................78
3.6.2 Technology
Objects Management (TOM)....................................................................................85
3.7 Diagnos
ing the technology configuration.....................................................................................87
3.7.1 Ov
erview ......................................................................................................................................87
3.7.2 Preparations
.................................................................................................................................87
3.7.3 Ax
is test using the technology axis control panel ........................................................................89

Siemens SIMATIC S7-300 Module data Specifications

General

Series	S7-300
Manufacturer	Siemens
Protection Class	IP20
System	SIMATIC S7-300
Digital Inputs	Varies by module
Digital Outputs	Varies by module
Analog Inputs	Varies by module
Analog Outputs	Varies by module
Central Processing Unit	Varies by CPU model
Supply Voltage	24V DC or 120/230V AC
CPU Type	Varies (e.g., CPU 312, CPU 315, etc.)
Memory	Varies by CPU model
Communication Interfaces	MPI, PROFIBUS
Programming Languages	LAD, FBD, STL, SCL, GRAPH
Operating Temperature	0°C to 60°C
Storage Temperature	-40°C to 70°C
Relative Humidity	10% to 95% (non-condensing)