EasyManuals Logo

Siemens SIMATIC S7-300 Module data Product Information

Siemens SIMATIC S7-300 Module data
208 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
Commissioning
3.4 Configuring the drive components
Connection of the SINAMICS S120 to the Technology CPU
36 Product Information, 09/2011, A5E00480378-04
Procedure
1. Use the Project > Connect to target system menu command to establish an online
connection to the SINAMICS S120 in S7T Config.
2. Place the SINAMICS S120 in the initial state by restoring the factory settings.
To do this, mark "SINAMICS_S120" and select the
Target device > Restore factory settings menu command in the shortcut menu.
Pay attention to any messages and acknowledge them. Also save the factory settings in
the ROM of the drive.

Table of Contents

Other manuals for Siemens SIMATIC S7-300 Module data

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC S7-300 Module data and is the answer not in the manual?

Siemens SIMATIC S7-300 Module data Specifications

General IconGeneral
SeriesS7-300
ManufacturerSiemens
Protection ClassIP20
SystemSIMATIC S7-300
Digital InputsVaries by module
Digital OutputsVaries by module
Analog InputsVaries by module
Analog OutputsVaries by module
Central Processing UnitVaries by CPU model
Supply Voltage24V DC or 120/230V AC
CPU TypeVaries (e.g., CPU 312, CPU 315, etc.)
MemoryVaries by CPU model
Communication InterfacesMPI, PROFIBUS
Programming LanguagesLAD, FBD, STL, SCL, GRAPH
Operating Temperature0°C to 60°C
Storage Temperature-40°C to 70°C
Relative Humidity10% to 95% (non-condensing)

Related product manuals