Siemens SIMATIC S7-400 CP 440

To Next Page

To Previous Page

Table of contents

Point-to-point connection CP 440 Installation and Parameter Assignment

Manual, 09/2007, A5E00057742-03

Table 9-2 CP 440 1 CYC...........................................................................................................................129

Table 9-3 CP 440 ASCII BCC . ..................................................................................................................130

Table 9-4 CP 440 MASTER . .....................................................................................................................130

Table 9-5 CP 440 SLAVE..........................................................................................................................131

Table 9-6 Generation of BCC HI ASCII characters "32" =2. .....................................................................135

Table 9-7 Generation of BCC LO ASCII characters "35" =5. ....................................................................135

Table A-1 Technical Specifications of the X27 (RS 422/485) Interface . ...................................................139

Table A-2 Technical Specifications of the 3964(R) Procedure. .................................................................139

Table A-3 Technical Specifications of the ASCII Driver . ...........................................................................140

Table A-4 Transmission Times with the ASCII Driver in ms. .....................................................................141

Table A-5 Transmission Times with the 3964(R) Procedure in ms. ..........................................................141

Table B-1

Pin Assignment for the 15-Pin Subminiature D Female Connector of the Integrated

Interface of the CP 440 . ............................................................................................................143

Table C-1 Order Numbers of the CP 440 Module . ....................................................................................149

Table C-2 Order Numbers of the Cables. ..................................................................................................149

Table D-1 Manuals for Configuring and Programming the S7–400. ..........................................................151

该文档是极速PDF编辑器生成，

如果想去掉该提示,请访问并下载：

http://www.jisupdfeditor.com/

长沙工控帮教育科技有限公司

www.gkbpx.com

Siemens SIMATIC S7-400 CP 440 - Page 11