Glossary
Glossary-3
S7-400 and M7-400 Programmable Controllers, Installation Manual
C79000-G7076-C424-01
Configuring is the assigning of modules to racks or slots and (with
signal modules) addresses.
These are the clips with which the modules are mechanically
interconnected within an M7 module assembly.
Counters are an area in the system memory of the CPU. The contents
of these counters can be changed using STEP 7 instructions (for
example, up counter, down counter).
³ Communications Processor
Central processing unit of the S7 or M7 programmable controller with
processor, arithmetic unit, memory, operating system, and
programming device interface.
A cyclic interrupt is generated by the S7-400 CPU periodically
according to a programmable time interval. A corresponding
organization block is then executed.
D
Data blocks are areas in the user program which contain user data.
There are shared data blocks which can be accessed by all logic
blocks, and there are instance data blocks which are associated with a
particular function block (FB) call.
Static data are data which are used only within a function block. These
data are stored in an instance data block belonging to the function
block. The data stored in the instance data block are retained until the
next function block call.
Temporary data are local data of a block that are stored in the L stack
during processing of the block and that are not retained after
processing.
A default setting is an expedient basic setting which is always used
when no other value is preset by a parameter.
³ System Diagnostics
Configuring
Connecting Clip
Counters
CP
CPU
Cyclic Interrupt
Data Block (DB)
Data,
Static
Data,
Temporary
Default Setting
Diagnostics
www.PLCworld.cn
To Next Page
Loading...
