Assembling the M7-400
8-39
S7-400 and M7-400 Programmable Controllers, Installation Manual
C79000-G7076-C424-01
8.7.3 Connecting a Programming Device (PG) to the M7-400
Connecting a Programming Device (PG) to the M7-400
You can connect the programming device via a preassembled programming device
cable to the MPI of the CPU.
Alternatively, you can fabricate the connecting cable with the PROFIBUS-DP bus
cable and bus connectors (see Chapter 5).
Shown in Figure 8-17 are the components for connecting a programming device to
the M7-400.
PG cable
M7-400
Programming
device
Figure 8-17 Connecting a Programming Device to the M7-400
www.PLCworld.cn
To Next Page
Loading...
