Siemens Simatic S7-400 - Page 32

Installing the S7-400
2-12
S7-400 and M7-400 Programmable Controllers, Installation Manual
C79000-G7076-C424-01
M6 threaded bolt
Terminal
Plain washer
Contact washer
M6 nut
To chassis
ground
Step 4: Mounting Additional Racks
If you assemble an S7-400 with two or more racks, you must allow additional
clearance between the individual racks or install a fan subassembly or cable duct.
The figure below shows the clearance you must allow between two racks of the
S7-400 during installation.
110 mm
         
         
www.PLCworld.cn
长沙工控帮教育科技有限公司整理
www.gkbpx.com