Reference
You can nd the certicates for the markings and approvals on the Internet under
Service&Support.
Safety instructions
WARNING
Personal injury and damage to property may occur
Note the following information for use in hazardous areas:
• Personal injury and material damage can occur if you establish or disconnect an electrical
circuit while the automation system is in operation.
• Always ensure to de-energize the system before removing the plug connections.
Note
The coupling module CP 440 for point-to-point connections is intended for use in industrial
areas. If used in residential areas, it may interfere with radio/TV reception.
10.2.2 CE approval
Introduction
The coupling module CP 440 for point-to-point connections fullls the requirements and
protective aims of the following EC directives and conforms with the harmonized European
standards (EN) that have been published for programmable logic controllers in the Ocial
Journals of the European Community:
• Low Voltage Directive
• EMC Directive
• Explosion Protection Directive
The EC Declaration of Conformity can be downloaded from the Internet.
Low Voltage Directive
2014/35/EU "Electrical Equipment Designed for Use within Certain Voltage Limits" (Low Voltage
Directive)
Technical specications
10.2 Standards and approvals
Point-to-point connection CP 440 Installation and Parameter Assignment
Equipment Manual, 03/2022, A5E00057742-AE 121
To Next Page
Loading...
