5.2 Installing the Programming Interface
Installation
The CP 440: Point -to-Point Communication, Parameter Assignment interface is supplied
together with the function blocks and the programming examples on a CD.
To install the engineering tool:
1. Insert the CD into the CD drive of your programming device/PC.
2. In Microsoft Windows, open the dialog for installing software by double-clicking the "Add
and Remove Programs" icon in the "Control Panel".
3. In the dialog box, select the CD drive and the "Setup.exe" le and start installation.
4. Follow the step-by-step instructions of the Setup program.
5.3 Parameters for the Communications Protocols
Introduction
Once you have entered the communication processor in the conguration table, you must
supply parameters to it and its serial interface.
Parameter assignment
The term "parameter assignment" is used in the following to describe the setting of protocol-
specic parameters. This is done using the CP 440: Point-to-Point Communication, Parameter
Assignment interface.
You start the programming interface by double-clicking the order number (CP 440) in the
conguration table or by selecting the CP 440 and selecting the Edit > Object Properties menu
command. The "Properties - CP 440" dialog box appears.
Click on the "Parameters" button to go to protocol selection. Set the protocol and double-click the
icon for the transmission protocol (an envelope). This takes you to the dialog for setting the
protocol-specic parameters.
Further Information
The basic operation of the Point-to-Point Communication, Parameter Assignment
programming interface is the same for all communication processors and is self-explanatory. For
this reason, the parameter assignment interface is not described in detail here.
Conguring and Parameter Assignment the CP 440
5.3 Parameters for the Communications Protocols
Point-to-point connection CP 440 Installation and Parameter Assignment
56 Equipment Manual, 03/2022, A5E00057742-AE
To Next Page
Loading...
