Siemens Simatic S7-400

Commissioning the CP 440
3
Step Sequence
Before starting up the CP 440 you will need to perform the following steps in the speci󹪝ed
sequence.
1. Mounting the CP 440
2. Con󹪝guring the CP 440
3. Assigning parameters to the CP 440
4. Backing up con󹪝guration data
5. Creating a user program for the CP 440
6. Commissioning the physical interface
Mounting the CP 440
Mounting the CP 440 involves inserting it into the mounting rack of your programmable
controller.
You can 󹪝nd a detailed description in the chapter "Mounting the CP 440 (Page 53)" of this
manual.
Connecting the CP 440 to the Communication Partner
The connection to your communication partner is made using the cable.
Con󹪝guring the CP 440
Con󹪝guration of the CP 440 includes its entry in the con󹪝guration table. Con󹪝gure your CP 440
using the STEP 7 software.
You can 󹪝nd a detailed description in the chapter "Assigning parameters to the CP 440
(Page 55)" of this manual.
Assigning parameters to the CP 440
Assigning parameters to the CP 440 involves creating the speci󹪝c parameters of the protocols.
Perform parameter assignment of the CP 440 from the programming interface Point-to-Point
Communication, Parameter Assignment.
You can 󹪝nd a detailed description in the chapter "Parameters for the Communications Protocols
(Page 56)" of this manual.
Point-to-point connection CP 440 Installation and Parameter Assignment
Equipment Manual, 03/2022, A5E00057742-AE 49