Siemens SIMODRIVE 611-D - Enter NC Machine Data (up to SW 2 Only)

More user manuals on ManualsBase.com
09.95

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
2-17
SINUMERIK 840C (IA)
2.12 Enter NC machine data (up to SW 2 only)
START
Data area
Parameter
softkey
1)
NC diagnostics
softkey
NC start-up
softkey
Press PLC MD
softkey
Go back with
RECALL key
General reset mode
softkey
END
Correct PLC MD
Entries cannot be made until
password has been entered
Start-up
end softkey
Enter PLC MD
2 General Reset and Standard Start-Up
2.12 Enter NC machine data (up to SW 2 only)
1) SW 1 only