Siemens SIMOTICS CONNECT 400 - Page 93

Procedure
1. Select "Motor Monitoring" or "Generic Vibration monitoring". "Motor Monitoring" is selected
in the following example.
2. Enter the serial number and the product article number. The following options are available:
– Manual entry of the serial number and the product article number
Enter the serial number and the product article number of the motor in the relevant
󹪝elds.
– Scanning the data matrix code of the motor
If the motor is equipped with a scannable code, you can identify the motor to which you
have local access. The scan reads the serial number and the product article number.
Scan the "Data Matrix Code" of the motor by tapping the "Scan Data Matrix" button.
Note
Motor assignment by scanning the data matrix code is only possible if the Siemens motor
has been provided with a 2D code.
Commissioning
6.3Commissioning with iOS
SIMOTICS CONNECT 400
Operating Instructions, 04/2023, A5E50161952B AL 91