Siemens SIMOTICS Series Hardware Installation Manual

Decommissioning and disposal
11.2 Decommissioning
SIMOTICS M-1FE2 built-in motors
Hardware Installation Manual, 04/2020, A5E50074509B AA
187
11.2.2 Disassembling the motor
This chapter provides instructions on disassembling the motor.
Precondition
Disassemble the motor with appropriate expertise.
When disassembling synchronous motors, observe the safety instructions for handling
permanent magnets.
Special safety notices for handling built-in motors (Page 19)
Procedure for disassembling a synchronous motor
WARNING
Injury or material damage if not correctly disassembled
If you do not correctly disassembly direct drives or their components (especially
components with permanent magnets), then this can result in death, severe injury and/or
material damage.
• Ensure that direct drives and their associated components are correctly disassembled.
Note
Disassembling the synchronous motor
The motor must be disassembled
by an authorized company or the manufacturer.
Procedure for disassembling an asynchronous motor
1. Disassemble the motor.
2. Dispose of the motor parts or return the motor parts to the manufacturer.
Dispose of the motor parts according to the instructions in Chapter "Disposal (Page 188)".
❒

Siemens SIMOTICS Series Specifications

General

Product brand name	SIEMENS
Product designation	SIMOTICS
Efficiency Class	IE1, IE2, IE3, IE4
Ambient Temperature	+60°C
Altitude	Up to 4000 m
Frame Size	63 to 355
Protection Class	IP55, IP56, IP65