Interfaces
3.6 PROFIBUS DP interfaces
D4x5
Manual, 05/2009
49
Position of connectors
The following figure shows the mounting position and designation of the connectors on the
control unit.
'303,
;
;
'3
Figure 3-6 Position of connectors X126, X136
Connectable devices
The following devices can be connected to the PROFIBUS DP interfaces:
● PG / PC
● SIMATIC HMI devices
● SIMATIC S7 controllers with PROFIBUS DP interface
● Distributed I/O
● Teleservice adapter
● Drive units with PROFIBUS DP interface (standard slaves)
Note
A teleservice adapter can only be connected to one of the two interfaces.
A detailed, regularly updated list of the modules approved for use with SIMOTION, as
well as notes on their use, can be found on the Internetat
(
http://support.automation.siemens.com/WW/view/en/11886029):
Take note of the documentation on the individual modules or devices!
To Next Page
Loading...
