Contents 01.04
0-2 Siemens AG 6SG7000-0BA76
SIMOTRAS HD Operating Instructions
Page
6.2.1.4 Using SIMOTRAS HD in an industrial environment 6-7
6.2.1.5 Non-grounded supply systems 6-7
6.2.1.6 EMC planning 6-7
6.2.2 Proper EMC installation of drives (installation instructions) 6-8
6.2.2.1 General 6-8
6.2.2.2 Rules for proper EMC installation 6-8
6.2.2.3 Arrangement of components for converters 6-16
6.2.2.4 List of recommended RI suppression filters 6-17
6.3 Parallel connection of converters 6-18
6.3.1 Circuit diagram showing parallel connection of SIMOTRAS converters 6-18
6.3.2 Parameterization of SIMOTRAS converters for parallel connection 6-19
6.4 Power connections 6-20
6.5 Fuses 6-25
6.6 Terminal arrangement 6-26
6.7 Terminal assignments 6-29
6.7.1 Overview of terminal connections on the electronics module
C98043-A7001 (CUD1) 6-29
6.7.2 Overview of terminal connections on the optional terminal expansion module
C98043-A7006 (CUD2) 6-29
6.7.3 Terminal description 6-30
7 Start-up
7.1 General safety information 7-1
7.2 Operator control panels 7-3
7.2.1 Simple operator control panel (PMU) 7-3
7.2.2 User-friendly operator control panel (OP1S) 7-4
7.3 Parameterization procedure 7-5
7.3.1 Parameter types 7-5
7.3.2 Parameterization on simple operator control panel 7-6
7.4 Restore factory setting 7-7
7.5 Notes to be read before switching on 7-8
7.6 Start-up procedure 7-9
7.6.1 Access authorization 7-9
7.6.2 Adjustment of converter rated currents 7-9
7.6.3 Adjustment to actual converter supply voltage 7-9
7.6.4 Input of motor data 7-9
7.6.5 Actual speed sensing data 7-10
7.6.5.1 Operation with pulse encoder 7-10
7.6.5.2 Operation with analog tacho 7-10
7.6.6 Speed setpoint data 7-10
7.6.6.1 Operation with analog setpoint 7-10
To Next Page
Loading...
