01.04 Connectors and binectors
SIEMENS AG 6SG7000-0BA76 12-27
SIMOTRAS HD Operating Instructions
Binector Name, description Function
diag., Sheet
B0203
Lower torque limitation active G160
B0204
Torque or current limitation active or current controller at limitation G163
Speed controller
B0205
Speed controller enabling by sequencing control G152
Setpoint processing, ramp-function generator
B0206
Limitation after ramp-function generator (setpoint limitation) has responded G137
B0207
Ramp-function generator output = 0 (y = 0) G136
B0208
Ramp-function generator, ramp-up G136
B0209
Ramp-function generator, ramp-down G136
B0210
1 = no direction of rotation enabled G135
B0211
Ramp-function generator: Enable setpoint (1 = setpoint enabled) G136
Torque limitation
B0212
“Zero delay-angle” command G160
Gating unit
B0220
Enabled torque direction for parallel drive G163
B0221
1 = Torque direction I active G163
B0222
1 = Torque direction II active G163
B0225
1 = active paralleling master [SW 2.1 and later] G195
B0230
1 = No torque direction requested [SW 2.1 and later] G163
B0231
1 = Torque direction I requested [SW 2.1 and later] G163
B0232
1 = Torque direction II requested [SW 2.1 and later] G163
Motorized potentiometer
B0240
Motorized potentiometer output = 0 (y = 0) G126
B0241
Ramp-up/ramp-down finished (y = x) G126
Brake control
B0250
Brake control (1=close brake, 0=release brake) G140
B0251
1=auxiliaries ON, 0=auxiliaries OFF see Sect. 9.7
B0252
1=converter fan ON, 0=converter fan OFF
B0255
B0250 inverted G140
B0256
B0251 inverted
Fixed control bits
B0421
Control bit 1 (P421) G120
B0422
Control bit 2 (P422) G120
B0423
Control bit 3 (P423) G120
B0424
Control bit 4 (P424) G120
B0425
Control bit 5 (P425) G120
B0426
Control bit 6 (P426) G120
B0427
Control bit 7 (P427) G120
B0428
Control bit 8 (P428) G120
Control inputs
B0500
Status of terminal 72 G117
B0501
Status of terminal 72, inverted G117
To Next Page
Loading...
