Siemens SINAMICS G120P - Page 54

Communication via PROFIBUS and PROFINET
3.3 PROFIdrive profile - Diagnostic channels
Fieldbuses
52 Function Manual, 04/2018, FW V4.7 SP10, A5E34229197B AE
Status messages, module status
For G120, independent of the status, for all slots “00” is always output, i.e. valid user data.
Channel-related data
2
Undervoltage
22
Motor overload
3
Overvoltage
23
Commun. with controller faulted
9
Error
24
Safety monit. Detected an error
16
Hardware/software error
25
Act. Position/speed value error
17
Line supply/filter faulted
26
Internal communication faulted
18
DC link overvoltage
27
Infeed faulted
19
Power electronics faulted
28
Braking controller faulted
20
Electronic component overtemp.
29
External signal state error
21
Ground/phase fault detected
30
Application/function faulted
When several faults are allocated at one inverter with the same message class, then only one mes-
sage is displayed.