Appendix
A.2 Directives and standards
Power Module PM240-2
168 Hardware Installation Manual, 01/2020, A5E33294624B AL
A.2 Directives and standards
Relevant directives and standards
The following directives and standards are relevant for the converters:
European Low Voltage Directive
The converters fulfil the requirements stipulated in Low Voltage Directive 2014/35/EU insofar
as they are covered by the scope of application of this Directive.
European Machinery Directive
The converters fulfil the requirements stipulated in Machinery Directive 2006/42//EU insofar
as they are covered by the scope of application of this Directive.
Use of the converters in a typical machine application has been fully assessed for
compliance with the main regulations in this Directive concerning health and safety.
Directive 2011/65/EU
The converter fulfills the requirements of Directive 2011/65/EU relating to the restriction of
the use of certain hazardous substances in electrical and electronic devices (RoHS).
European EMC Directive
By completely complying with IEC/EN 61800-3, it has been proven that the converter is in
compliance with Directive 2014/30/EU.
Underwriters Laboratories (North American market)
Converters bearing one of the certification marks shown on the left meet the requirements
for the North American market as a component of drive applications and are listed
correspondingly.
EMC requirements for South Korea
The converters with the KC marking on the rating plate satisfy the EMC requirements for
South Korea.
Eurasian conformity
The converters comply with the requirements of the Russia/Belarus/Kazakhstan customs
union (EAC).
To Next Page
Loading...
