Siemens SINAMICS PM240-2 - 2 Introduction

Power Module PM240-2
Hardware Installation Manual, 01/2020, A5E33294624B AL
17
Introduction
2
Overview
The Power Modules belong to the modular family of SINAMICS G120 converters. A modular
converter comprises a Control Unit and a Power Module.
Depending on the power rating in frame sizes FSA … FSG, the following Power Module
versions are supplied:
•
1 AC 200 V
0.55
kW … 4 kW
for line voltages from 1
AC 200 V … 240 V
•
3 AC 200 V
0.55
kW … 55 kW
f
or line voltages from 3 AC 200 V … 240 V
•
3 AC 400 V
0.55
kW … 250 kW
for line voltages from 3
AC 380 V … 480 V
•
3 AC 690 V
11
kW … 250 kW
for line voltages from 3
AC 500 V … 690 V
Control Units for the Power Modules
You can operate the Power Modules with a Control Unit from one of the following listed
families:
● CU230P-2
● CU240B-2
● CU240E-2
● CU250S-2
For Power Modules FSA … FSC, you require a Control Unit with firmware version V4.4 or
higher.
For Power Modules FSD … FSF, you require a Control Unit with firmware version V4.7 HF8
or higher.
For Power Modules FSG, you require a Control Unit with firmware version V4.7 SP9 or
higher.
Note
Commissioning the converter
You must first commission the converter before you can use it. Commissioning is described
in the
Operating Instructions of the relevant Control Unit.
Manuals for your converter (Page 163)