Siemens SINAMICS PM240-2 - Sequence for installing the Power Module

Installing
3.4 Mounting the Power Modules
Power Module PM240-2
30 Hardware Installation Manual, 01/2020, A5E33294624B AL
3.4.1 Sequence for installing the Power Module
During installation, comply with the sequence listed below.
Frame sizes FSA ... FSC
1. Prepare the cabinet.
2. Mount the shield plates.
3. Install the Power Module.
4. If you are using a Brake Relay or Safe Brake Relay:
Install the Brake Relay next to the converter.
Frame sizes FSD … FSG
1. Prepare the cabinet.
2. If you are using a Brake Relay or Safe Brake Relay:
Install the Brake Relay on the rear side of the shield plate.
3. Mount the shield plates.
4. Install the Power Module.