Siemens SINAMICS PM240-2 - Dimension drawings and drilling dimensions for PT Power Modules

Installing
3.4 Mounting the Power Modules
Power Module PM240-2
Hardware Installation Manual, 01/2020, A5E33294624B AL
33
3.4.3 Dimension drawings and drilling dimensions for PT Power Modules
Use the optional mounting frame to mount a Power Module in push-through technology in a
control cabinet. The mounting frame includes the necessary seals and frame to ensure
compliance with degree of protection IP55.
If you do not use the optional mounting frame, then you must ensure that the required
degree of protection is complied with using other appropriate measures. Mounting
instructions are provided in the following section:
Mounting frames for PT power modules (Page 118)
The following dimension drawings and drilling patterns are not to scale.
Frame sizes FSA ... FSC
Wall thickness of the control cabinet ≤3.5 mm
Figure 3-5 Dimension drawing and drilling dimensions for frame sizes FSA ... FSC