Power Module PM240-2
Hardware Installation Manual, 01/2020, A5E33294624B AL
67
Fire or electric shock due to defective components
If an overcurrent protection device is triggered, the converter may be defective. A defective
converter can cause a fire or electric shock.
• Have the converter and the overcurrent protection device checked by a specialist.
Repair
Fire or electric shock due to improper repair
Improper repair of the converter may cause malfunctions or result in consequential damage
such as fire or electric shock.
• Only commission the following persons to repair the converter:
– Siemens customer service
– A repair center that has been authorized by Siemens
– Specialist personnel who are thoroughly acquainted with all the warnings and
operating procedures contained in this manual.
• Only use original spare parts when carrying out repairs.
Recycling and disposal
For environmentally-friendly recycling and disposal of your old device, please contact a
company certified for the disposal of waste electrical and electronic equipment, and dispose
of the old device as prescribed in the respective country of use.
To Next Page
Loading...
