Siemens SINAMICS PM240-2 - Page 57

Connecting
4.2 Connecting the line and motor cable at the converter
Power Module PM240-2
Hardware Installation Manual, 01/2020, A5E33294624B AL
55
Figure 4-7 Connecting the PM240-2 Power Module, 200 V 1 AC, FSA ... FSC
Note
Connecting PM240-2 Power Modules, 200 V to 1 AC - only FSA ... FSC
Fo
r the 200 V versions and single-phase line systems, connect the phase conductor and
neutral conductor to any two of the terminals L1, L2, L3.
Connect cables at the converter so that they are EMC compliant
Attach the cable tie holders to the Power
Module as shown to t
he left in the diagram
before you establish the connections.
Fix the line connecting cable using a cable tie
as shown in
①.
Fix th
e shield of the motor connecting cable
using a hose clamp (
②).
Connect the shield of the control cable with
the shield plate o
f the Control Unit (③) using
a steel band. Also attach the control cable to
the Power Module using a cable tie (④).