Connecting
4.2 Connecting the line and motor cable at the converter
Power Module PM240-2
Hardware Installation Manual, 01/2020, A5E33294624B AL
59
Connections for frame sizes FSD … FSG
You must remove the covers from the con-
nections in order to connect the line supply,
braking resistor and motor to the converter.
In addition, for frame sizes FSD and FSE,
release the two terminal scr
ews on the
tions for the motor and braking re-
sistor, and remove the dummy plug.
For frame sizes FSF and FSG, you must
breakout the openings from the connection
cover for the power connections. Use side
cutters or a fine saw blade.
FSD … FSG: Remove the top covers
FSD, FSE: Remove the lower cover
FSF, FSG: Remove the lower cover
To Next Page
Loading...
