Siemens SINAMICS SM150

4.3 Transportation
The terms are defined as follows in the following part of the instructions:
● "Transportation unit" refers to the unit before it has been unpacked
● "Cabinet" refers to the unit after it has been unpacked
4.3.1 Transport markings
The packing differs depending on the transport type and size. If not otherwise contractually
agreed, the packaging corresponds to the packing guidelines for International Standards for
Phytosanitary Measures (ISPM).
Note the symbols which appear on the packing. These have the following meanings:
Top Fragile material Keep dry Keep cool Center of
gravity
Do not use
hand hook
Attach here
4.3.2 Transport requirements
● Persons driving cranes and fork-lift trucks must hold appropriate licenses.
● You must observe the specifications to avoid transport damage to the enclosure and you
must maintain the permissible climatic conditions during operation in accordance with
IEC 60721-3-1/2/3. Please also observe the "Technical specifications" instructions.
● When lifting the drive, use only approved and undamaged sling guides and spreaders of
sufficient rated capacity. Check these before using them. The weight of the drive is specified
on the rating plate.
● When lifting, refer to the information on the lifting plate or in "Technical data and drawings."
Comply with the specified spreading angles.
NOTICE
Vibrations
Significant vibration during transportation and shocks when setting down can damage the
equipment.
Avoid vibrations and shocks.
Preparations for use
4.3 Transportation
SINAMICS SM150 6SL3845-7NN46-7AA0
86 Operating Instructions 04/2017