Installing and putting a SINAUT modem into operation
5.5 MD2 dedicated line modem
Station control system
208 System Manual, 07/2009, C79000-G8976-C178-07
The pinout of the two RJ-12 plugs is identical.
Note
It is best to hold the cable just below the RJ-12 plug. This makes it easier to insert the plug
than if you hold the RJ-12 plug itself. When inserting it, make sure that you can hear the RJ-
12 connector click into place!
5.5.4 Connecting the MD2 with TIM, LTOP and dedicated line
Introduction
The following figures illustrate the various options for connecting the MD2 modem to a TIM
or other MD2 modems as well as to a dedicated line over an LTOP.
For more detailed information on connecting, wiring up and setting the LTOP, refer to the
section
Line transformer with LTOP overvoltage protection
.
To Next Page
Loading...
