Siemens SINAUT ST7 - Connecting the MD3 with a TIM and TAE6 Outlet

Installing and putting a SINAUT modem into operation
5.7 Analog dial-up modem MD3
Station control system
246 System Manual, 07/2009, C79000-G8976-C178-07
5.7.4 Connecting the MD3 with a TIM and TAE6 outlet
The following figure summarizes how the MD3 modem is connected to a TIM (over RS-232)
and with the telephone outlet (TAE6N jack) in dialing mode using the specified standard
connecting cables. A telephone can also be connected to the same telephone outlet as the
modem (using the TAE6F jack).
7,0
0'
56
1+$/FRQQHFWLQJFDEOH
56
5- 7$(1
7$()
1+$5FRQQHFWLQJFDEOH
7HOHSKRQHVRFNHW
Figure 5-36 Connecting the MD3 with a TIM and telephone outlet
Note
Any TIM with an RS-232 port can be used, in other words, the TIM 3V-IE variants, the
TIM 4R-IE and all TIM 4 types.
Connecting an MD3 and a telephone in parallel to a TAE6 outlet
The following figure shows how to connect an MD3 and a telephone in parallel to a TAE6
outlet. The diagram shows the standard wiring of the TAE6 socket of the German Telekom
with a connection for one telephone (TAE6F) and a connection for a modem or a fax
machine (TAE6N).