Introduction to the SINAUT ST7 system
1.9 The SINAUT ST7 standard software package
Station control system
66 System Manual, 07/2009, C79000-G8976-C178-07
1.9.3 Overview for ordering SINAUT ST7 software
Table 1- 9 Overview for ordering SINAUT ST7 software
Short name Order no. Explanation
SW ST7 6NH7997-0CA15-0AA0 Standard software for SINAUT ST7, consisting of
SINAUT TD7 library with blocks for the CPU
SINAUT ST7 configuration and diagnostic software for the
programming device
Electronic manual (German/English)
UPGR SW ST7 6NH7997-0CA15-0GA0 ST7 software upgrade package for owners of SINAUT ST7
standard software packages less than V4.0
1.9.4 Installation of the SINAUT ST7 standard software package
The following requirements must be met to install any or all components of the software
package:
● Operating system: Windows Server 2003 SP2, Windows XP SP2 or Windows Vista 32 Bit
Ultimate and Business
● The installed STEP 7 software must be version 5.4 SP4 or higher.
If the
Autorun
feature is activated on your PC/PG, the SINAUT ST7 setup program starts
automatically when you insert the CD. Otherwise, use the Explorer to open the root directory
on the CD and click on the
Setup.exe
application.
The setup program checks which components on the CD can be installed and then displays
a list from which you can make your selection. Setups are currently available for the
following components.
● SINAUT ST7 configuration: Basic version V5.0
● SINAUT TD7 library V2.2
Figure 1-24 Master setup dialog
To Next Page
Loading...
