Installing and putting a SINAUT modem into operation
5.7 Analog dial-up modem MD3
Station control system
230 System Manual, 07/2009, C79000-G8976-C178-07
Illustration Pin no. Signal name Signal direction Remark
4 DTR Input
5 GND
6 DSR Output
7 RTS Input
8 CTS Output
9 RI / T Output
The X2 RS-485 connector is designed as a 9-pin D-sub miniature female connector. The
pinout is shown in the following table.
The RS-485 interface can be activated and the terminating resistor activated using a 4-pin
DIL switch accessible from below through the housing grill.
Table 5- 25 Pinout of the X2 RS-485 connector
Illustration Pin no. Signal name Signal direction Remark
1
2
3 Data B Bidirectional
4
5 M5 - 0 V for bus termination in
connector
*)
6 P5 - 5 V for bus termination in
connector
*)
7
8 Data A Bidirectional
5 4 3 2 1
9
*) It is advisable to activate the terminating resistor for the RS-485 bus in the connector and not in the modem itself.
Standard connecting cable for the RS-232 and RS-485 port
The TIM module or other terminal device with a suitable interface is connected to the X1 9-
pin RS-232 connector or the 9-pin X2 RS-485 jack.
The following standard connecting cables are available for the X1 connector or X2 jack.
To Next Page
Loading...
