Installing and putting a SINAUT modem into operation
5.8 ISDN dial-up modem MD4
Station control system
266 System Manual, 07/2009, C79000-G8976-C178-07
4. Power supply OFF, set switch 3 to OFF
5. Select basic setting for dedicated line mode or standard profile for dialing mode and then
power ON
2))
21
Figure 5-50 Setting the DIL switch to reset the MD4 modem
Note
Following the reset, the settings made with the terminal program for the dedicated line
mode are deleted. The settings must therefore be transferred to the modem again using
the terminal program.
Factory setting on the DIL switch
When it ships, the modem has the following default settings:
● Standard profile 0: AT mode
● Reset OFF
When shipped, the switches are set as shown in the following figure.
2))
21
Figure 5-51 Factory setting on the DIL switch
To Next Page
Loading...
